![]() ![]() ![]() ![]() (As I think this is what caused my issue of no communication in the first place) I reinstalled the BOSCH software again so IDS didn’t prompt me to update to the newer version of the software from September 2014 vs February 2014 (.3). I also updated IDS to version 95.05 and using a 3 day trial after upgrading from version 91.01. I reinstalled the firmware in recovery mode using Ford_VCM_II_Software_Setup_v2.1.119.3 from the BOSCH website. Having talked about with some repairing friends and forum guys, I decided to have a try with my FORD VCM II. I don’t need to be doing a file transfer such as a module programming and increase the already present chance of a connection dropout. This one has the WiFi, but given its a clone I will most likely only chance the wired USB. I seen some other images around the interwebs that show PCB’s that don’t look all that great. The quality looks good on the PCB and no lose connections from what I can see. Worried about the quality, I decided to see the PCB. IDS detected the VCM II just fine, the lights light up correctly, but when I plugged it into my 2014 Ford Fusion it would not detect the PCM to establish any communication.Īns I did not know if it is necessary to reflash different software or downgrade. I just got a clone VCM II from China, and then I installed IDS V95 and it did a software update which finished successfully. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |